• Balancing of the drive train
• Testing the rear axle drive in the installed condition (NVH = Noise vibration harshness,VAD = Vibro-acoustic diagnosis)
• Function test
• Automatic test sequence

Special features

• Modular construction as a single station with free positioning of test part (installation position)
• Powerful industrial PC for control of the test sequence and measured value processing
• Software module for VAD procedure and measurement of static unbalance; large rotor type data memory, operator prompting, diagnostic program, statistics, process control, external interfaces
• Single or multiple-channel noise checking with integrated unbalance recognition
• Flexible application, easy change over for various rearaxle modules
• Special system adaptation to the requirements of objective noise testing, such as structural isolation of the test equipment as well as high-repeatability, test part coordinated sensor coupling of the test part support.
• Automatic coupling of the part at the shaft ends
• Automatic recognition of the possible correction position
• With manual correction automatic indexing to the correction position and display of the correction weights
• Protection against shaft breakage.

Range of application

Quality testing of drive modules (front-mounted rear-axle with drive shafts) of passenger vehicles and light commercial vehicles.

Suitable for measurement and correction of the unbalance, improvement of the NVH characteristics through vibro-acoustic evaluation of the assembly structure as well as diagnosis of the noise properties of components (differential, drive shaft, bearing).

Application in production, integrated into the assembly line.

Design

Single-station machine with fully automatic test sequence, loading and unloading by a pallet system.

Consisting essentially of vibration isolated machine frame for testing as if installed, measurement and control cabinet with test-stand PC and drive, positioning device for adaptation to the work-piece type on hand, protective enclosure.

Sequence of operations

• Transport the rear-axle module on pallet by roller conveyor and close the protective equipment (loading door)
• Lift the pallet, clamp, couple the drive and synchronizer, attach the sensors for unbalance measurement, lower the pallet, close the safety devices.
• Fully automatic test sequence: Check the length of the drive shaft (with type mix), run up and regulate the load, measure the required torque and differential ratio, measure the initial unbalance, structure-borne sound and the possible test weight and correction positions, brake, index, add the test weight, and carry out a further measuring run, brake, index, remove the test weight, calculate the co- efficient and initial unbalance. Compare with tolerances (for coefficient and unbalance).
• When out of tolerance: Index for unbalance correction, open the operating doors, manually add the unbalance correction according to the display, close the doors and perform a check run.
• When in tolerance: Mark, travel to home position, open loading doors, move the pallet out.